![]() To use DVI, you must have a DVI-compliant graphic card. Setting Up the Monitor Connecting the VGA (Analog) or DVI-D (Digital) Cable Use a VGA video cable or a DVI-D video cable (cables provided with select models). 100 x 100mm Threaded holes for attaching wall mount 100 x 200mm Threaded holes for attaching wall mount 6. You will need to remove the screws, position the mounting device, then re-install the screws. Some models will include mounting screws in the mounting holes. These holes are for screws to attach the swing arm or other mounting fixture to the back of the monitor. Setting Up the Monitor Four or six threaded holes are exposed (depending on your model). Use a coin at the base of the plate to pry it loose. Remove the square plate on the back of monitor. Sliding the base away from the monitor 5. Slide the base away from the bottom of the monitor. Refer to the instructions supplied with the wall-mounting fixture and check that it is capable of supporting the monitor. Monitor in upright position Preparing the monitor for wall-mounting WARNING: To reduce the risk of personal injury or of damage to the equipment, check that the wall-mounting fixture is adequately installed and secured before attaching the monitor. Lift the monitor to an upright position and place on a flat, stable surface. You may need a flat, soft, protected area for placing the monitor screen-down while preparing it for installation. Prepare a flat area to assemble the monitor. See “Installing the Monitor” in this chapter. Determine whether the monitor will be desktop mounted or wall-mounted. Turn off the computer and other attached devices. ■ Turn your monitor off when not in use.ģ Setting Up the Monitor Unpacking the Monitor 1. ■ Adjust only those controls that are described in the operating instructions. If your monitor is not operating properly or has been dropped or damaged, contact your Hewlett-Packard authorized dealer, reseller, or service provider. Safety and Maintenance Guidelines Maintenance Guidelines To enhance the performance and extend the life of your monitor: ■ Do not open your monitor cabinet or attempt to service this product yourself. ![]() The grounding plug is an important safety feature. To reduce the risk of electric shock or damage to your equipment, do not disable the power cord grounding feature. WARNING: Always connect your monitor, the computer, and other equipment to a grounded (earthed) power outlet. To use a different cord, use only a power source and connection compatible with this monitor. ![]() ■ Ambient Light Sensor (select models only) ■ CD included: User’s Guide ❏ Drivers ❏ Auto-adjustment software ❏ Documents ❏ Adobe® Acrobat® Reader 1–2Ģ Safety and Maintenance Guidelines Important Safety Information The power cord is designed for use with your monitor. A–3 Locating the Rating Label.ġ Product Features HP LCD Monitors The HP LCD (liquid crystal display) monitors have an active matrix, thin-film transistor (TFT) screen. Ī Troubleshooting Solving Common Problems. 1–iii 1 Product Features HP LCD Monitors. CAUTION: Indicates that failure to follow directions could result in damage to equipment or loss of information.Ĭontents Notational Conventions. These blocks are notes, cautions, and warnings, and they are used as follows: WARNING: Indicates that failure to follow directions could result in bodily harm or loss of life. Notes, Cautions, and Warnings Throughout this guide, blocks of text may be accompanied by an icon. Notational Conventions The following section describes notational conventions used in this document. This document contains proprietary information that is protected by copyright. HP assumes no responsibility for the use or reliability of its software on equipment that is not furnished by HP. HP shall not be liable for technical or editorial errors or omissions contained herein. Nothing herein should be construed as constituting an additional warranty. ![]() The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |